Trunk cubby separator for Toyota C-HR BEV
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small separator that keeps items from sliding under the floor when it's set at its higher position.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 180
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution
2026-08-01 New V2 released
I ordered the original part from Subaru and re-did the model to better align with the dimensions of the real part, and attach to the vehicle with tabs, also like the real part.
There are two versions of V2: one that matches the real part near 1:1, and one with an extended base for better lateral stability. I am keeping the original model here in case you prefer a larger separator.
If you want the original Subaru part, its part number is 64743-42030-C0, "board deck trim side".
The Subaru Uncharted comes stock with small cubby separators that clip into the floor panels in the trunk and keep small items from sliding under the floor when it's set at its highest position.
My Canada-spec Toyota C-HR BEV didn't have the piece, so I designed a replacement. It should be easy to print flat on the build plate, in material that is heat-resistant. To install, use double-sided tape (I recommend "Alien Tape" style.
I don't plan to ever use the floor in the low position, but if you do you might need to modify the included OpenSCAD file to make the vertical flap lower (modify flpY value and re-render).
This should also work on the C-HR+.