Wall Lamp for 3 x LED GU5.3 / Regulable 45° Step
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall lamp for 3 x LED GU5.3 bulbs, 45° adjustable direction. For dry indoor use only.GU5.3
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 1
- Wyświetlenia
- 35
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
The lamp is designed for three LED lamps with a GU5.3 (MR16) base. The direction of the lamp is adjusted discretely in 45 degree increments. The case is designed for wall mounting in rooms protected from water and splashes.
Important: use only LED lamps (halogen lamps generate too much heat and can deform the plastic).
Assembly instructions:
Print out all the details. If necessary, print in parts with the fit check.
Assemble the electrical circuit, pull the supply wire out through the designated hole. Install the lamps.
Assemble the lamp leg by pre-selecting the desired lamp direction (locking through 45°) and fix the parts using a clip.
Assemble the housing with self-tapping screws.
Fix the lamp to the wall/ceiling, connect it to the mains.
Printing Recommendations:
Material: PETG or ASA (for heat resistance during long-term operation of high-power LED). PLA is acceptable, but less reliable when heated.
Layer: 0.2mm
Filling: 40% (for rigidity of fixing points)
The model contains two files:
FreeCAD 1.1 source file – fully editable CAD model for custom modifications (angle limits, mounting holes, etc.).
Ready‑to‑print profile for Bambu Studio – pre‑configured print settings