Baby Jumper Mounting Bracket (NO DOOR/LIP)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bracket used to hang a door mounted baby jumper, without the door frame/lip.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 0
- Wydruki
- 0
- Wyświetlenia
- 11
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
This bracket is designed to be screwed on both sides the beam at the top of an archway/doorway that lacks the required lip to hold a door mounted baby jumper. Uses 3 screws each, in my case I used #10 screws at 2in long. Works best with a small washer dropped into the screw slot to support the plastic, but when printed at 100% infill, it should hold up with just the screws. The screw port cover is simply for aesthetics. When both are gripped on either side of the arch, it holds my weight easily at 6'4" & 280 Lbs.
I recommend printing on the flattest faces, and at 100% infill and at .2 max layer height.