Creality K1 Max - Top mounted filament spool holder - bolt secured and spool bushing
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Paranoid remix - added bolts to secure the axle (against vibration) and bushing for different spool hole sizes
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 137
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This was all printed in PLA on the K1 Max at 0.2mm layer height. I used a 15% Gyroid infill, but I'm assuming almost any infill is fine. No supports are need for any piece.
For the bolts, I recommend 100% infill and a smaller layer height ( I used 0.08) to get maximum strength.
If the bolts are a little stiff, then use a little(!) silicon lube and it will work fine. I wouldn't use any silk or metallic / glitter filament on the bolts or threaded pieces. The bolts need only be lightly tightened, they are for security only.
The side supports are as per the original model except for the altered seating for the axle.