1 / 3
Router template for edge slots in X-Carve wasteboard — zdjęcie 1
1 / 3

Router template for edge slots in X-Carve wasteboard

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I bought the Inventables X-Carve kit with the plan of making my own wasteboard, but didn't have a convenient way to…

Ocena
0 / 5
Polubienia
8
Pobrania
23
Wydruki
0
Wyświetlenia
336
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

I bought the Inventables X-Carve kit with the plan of making my own wasteboard, but didn't have a convenient way to accurately cut the edge mounting slots 9mm to center from the edge. But I did have a 3D printer! This jig is large enough for my Porter Cable router with a 3/4" OD guide bushing with a little extra room for clamps. I didn't have Metric router bits, but I do have the Freud undersized plywood big set and plan to use the 7/32 (Freud 16-094) bit for the through slot and the 15/32 (Freud 16-109) bit for the 5mm stopped hole. The extra tab is 5mm thick for setting the depth stop on the router, and there is a raised line on the outside and notch on the inside to line up with layout marks. No support needed, 20% infill is fine. I had to sand some bumps off the inside, but once I did that the bushing fit like a glove.

Print Settings

Printer Brand:

MakerGear

Printer:

M2

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

20%

Post-Printing

I had to sand the inside straight edge to remove small bumps, but after that the router bushing fit perfectly.

Category: Parts

Tagi