1 / 4
LEGO style Lantern for LED lamp kit 001 with transparent paper — zdjęcie 1
1 / 4

LEGO style Lantern for LED lamp kit 001 with transparent paper

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of the design by @Jiri_G_45777 of a LEGO style Lantern for the LED lamp kit 001 with transparent paper.

Ocena
0 / 5
Polubienia
9
Pobrania
17
Wydruki
0
Wyświetlenia
144
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

This is a remix of the design by @Jiri_G_45777 of a LEGO style Lantern for the LED lamp kit 001 with transparent paper. I used the following print settings:

  • PLA

  • 10% infill, gyroid

  • 2 perimeters

  • Organic support everywhere (use colour tool to remove in the threads, see the PrusaSlicer project)

  • For aesthetics of the body, concentric line fill pattern for the top

Transparent paper

Instead of the 3D printed lamp shade this remix uses transparent paper. A yellow rectangle is printed on the paper to give the yellow glow, mimicking the real life appearance of a black Utensil LEGO lantern (37776) with the trans-yellow brick (3062). 

With a paper cutting machine I resized the printed rectangle to the correct fitting. For aesthetic reasons place the seam at one of the pillars so you don't see the seam from the outside. 

LED kit

As the LED 001 became way to hot (and it was too bright for my liking), I added a 23.5ohm (2x 47 ohm parallel) resistor in between the plus side of the 5V power line. Make sure you isolate it a bit with something like hot glue so the wires are not able to touch the aluminium. Also be aware of metal shavings when unscrewing the LED lamp. 

Assembling

Simply pull the wire of the LED kit through the hole in the cover and mount the lamp in the recess. If you like, again, use some hot glue to secure the lamp to the cover. Then insert the trans-yellow paper into the lantern's body and twist to lock it into place. And, turn it on 🙂

Thanks for the awesome model!
Happy printing and making!

Tagi