Lack enclosure for Elegoo Neptune 2, 3

All details are in the PDF uploaded:  Design, BOM, Printing, Some assembly details

Files you will find here:

• Photos
• PDF “Lack enclosure documentation_Vx.pdf”
• All STLs
• Full assembly in STEP

-------------------

• Our intent was to be able to print ABS with the Neptune
• Pop-able side panels for maintenance or printing PLA
• Top table including all panels and doors can be removed easily to allow working on the printer
• Modular panel brackets and door hinges to allow completely new configuration of panels and doors by other users
• PSU mounted outside the chamber and reusing OEM screws
• Spool mounted outside the chamber and reusing OEM screws and t-nuts

 

• Elegoo Neptune 2 (and 3) fits perfectly inside including Min to Max Y movement
• Total height available inside = 510 mm (20")

--------------------

Update 2024-01-30

• Enlarged the hole in all top corner spacers to allow the double ended screw that comes with the lack table to go through correctly.  The stopper in the middle of the screw probably changed as this was not an issue before
• Files updated:
  • Top corner Front Left_x1.stl
  • Top corner Front Right_x1.stl
  • Top corner Rear_x2.stl

Update 2022-11-24

• Updated 5 files to allow a regular 3/8" drive 7/16" socket in the C-Bore of the bottom corners when tightening the ¼" hex head screws 
• Files updated:
  • Bottom corner Front Left_x1.stl
    Bottom corner Front Right_x1.stl
    Bottom corner Rear_x2.stl
    Hinge pin clip L_x2.stl
    Hinge pin clip R_x2.stl

Update 2022-05-10

• Uploaded 2 missing parts:  Panel bottom holder A and B

Update 2022-04-21

• Added estimate for quantity of material in PDF
• Adjusted a couple of filenames (with qty to print) for consistency