1 / 1
Kryptonite lock bike frame hanger/clamp
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A hanger to attach a Kryptonite bike lock to your bike frame. Clamps onto the frame with four M4 bolts.
- Ocena
- 4 / 5
- Polubienia
- 24
- Pobrania
- 119
- Wydruki
- 2
- Wyświetlenia
- 1133
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (26)Powiązane
This is a replacement hanger to attach a Kryptonite bike lock to your bike frame. This is a complete remake, but inspired by an original from Peite, with a few changes:
- Cleaned up and some fillets added for strength and smoother looks.
- Takes M4 round-headed bolts - and the nuts are slightly countersunk into a fillet, which is enough to hold them tight when tightening. Suggest to check that your nuts/bolts fit before printing.
- The interface with the lock needed to be increased in size to fit my lock - I'm not sure to what extent different Kryptonite locks (or locks of different ages?) have slightly different sized hangers? Suggest to carefully measure your lock to ensure that this will work before printing.
- Designed to clamp to a 35.5mm diameter tube - of course, your bike frame size may well vary, so suggest to check this before printing.
- Printed with PLA, 100% infill, 0.15mm layers.