Supernova E3 Tail (K915) mount v1 (for 50mm placing)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount your Supernova light on every flat surface
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 39
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
I need to mount this little light to my Mudhugger rear mudguard so I made this model.
v2 is here: https://www.printables.com/model/1751103-supernova-e3-tail-k915-mount-v2-for-50mm-placing
Get v1 if you want to print it easier and get v2 if you need specific geometry. v2 is a bit longer (but v1 basement is wider).
It can be placed on every flat surface via 3 screws. I got bottom-wired version of light, but I also know about lights with wire on the back - and there is 10mm hole for mount it too. Unfortunately, I have not both versions, so if you can test this mount - it would be nice.
Use two M4 nylon lock nut (DIN 985) for mount light
DIN 7991 M4x12mm screws is the best choice for mount light but you can get longer if neccesary
Use DIN 912 M4 (x3 pcs) for mounting platform. Holes depth - 6mm.
Do not get too long screws because it would be dangerous for your tires
Using K915 light with bottom-wired version (as photo) you can drill 4th hole for hidden cable management or use special wire channel for placing it above surface. For back-wired lights just wrap the wire and put it on the backside of mounting plate.
Use screw locker or nylon nuts for prevent loosen during riding. Do not overtighten screws.
Hope it helps! Enjoy!