VETEK / FLATIC 64MP Toy Camera Lens Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lens cap with retainer loop for the 4k / 64MP "VETEK" toy camera
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 89
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Lens cap for a common keychain/toy camera. I had trouble finding a definitive name, but its usually sold under VETEK brand. I found mine under the brand FLATIC. Here are a few amazon example listings (not affiliate links):
https://a.co/d/0hzWkv52
You may need to shrink or grow the model very slightly depending on your printer/tolerances. This fit mine but YMMV. Its cheap to print. The fit should be a snug friction fit.
Print as oriented - front face of the lens cap down. You may get a warning about cantilevers, there isn't one though (idk, may have been an orca quirk - not sure).
I used the existing strap to retain the lens cap. Yank on each end of the strap on the thicker side at the plastic coupler, one side will pull out. The smaller cord will come with it, threaded through the sheath. Remove it carefully leaving the knot intact. The knot will fit through the hole in the lens cap but not the camera. Alternatively, any other extremely thin cord should work fine.