1 / 10
Mikrotik CRS305-1G-4S+IN 19-inch Rack Mount — zdjęcie 1
1 / 10

Mikrotik CRS305-1G-4S+IN 19-inch Rack Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MikroTik CRS305 Dual Rackmount — 1U, 19", LEDs Front, Fan-Ready

Ocena
0 / 5
Polubienia
2
Pobrania
19
Wydruki
0
Wyświetlenia
134
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution

MikroTik CRS305 Dual Rackmount — 1U, 19", LEDs Front, Fan-Ready

Mounts two MikroTik CRS305-1G-4S+ switches side by side in 1U of a standard 19" rack.

Most CRS305 rackmounts turn the switch around so the SFP+ cages face front — convenient for cabling, but you lose sight of the status LEDs. This design keeps the LEDs facing forward so you can read link state at a glance from the front of the rack.

The trade-off is honest: SFP+ cables attach from the side, and reaching the cages can be fiddly in a populated rack. This mount suits a set-and-forget installation, not a patch panel you re-cable weekly.

The rear-facing orientation has a second benefit: each switch position accepts a 40mm fan mount on the back (Noctua NF-A4x10 and NF-A4x20 both fit), pulling air through the chassis. The CRS305 runs warm passively, especially with multiple 10G optics.

Hardware required

  • 8× M3x5x4 heat-set inserts (Voron spec) — 4 per side, for the fan mounts

  • 8× M3x6 countersunk screws — attach the fan mounts

  • 4× M3 hex nuts + 4× M3x5 socket head screws — join the two halves

  • Standard cage nuts/screws for the rack ears

  • 2× 40mm fan, optional — Noctua NF-A4x10 or NF-A4x20 (mount accepts both depths)

Printing

Prints without supports. The included profile uses PETG.

 

Material: PETG or PCTG minimum — the switches run warm and PLA will creep over time. ASA/ABS preferred if your rack lives somewhere warm or the switches carry sustained 10G load.

 

The photos show the model printed in PCTG.

Fusion archive and step file included.

Support my work

Do you like my work?

A like or a comment means a lot and keeps me making more.

Post your make in the comments section and on other 3D printing social media sites.

Your support helps me keep designing, fund the filament and materials needed for prototyping, and share everything for free.

Consider buying me a coffee.

Check out my other designs too!

Tagi