1 / 1
Moonlit Market Classic Connect 2 Glue Clamp — zdjęcie 1

Moonlit Market Classic Connect 2 Glue Clamp

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A clamp to hold the iPod front tight inside a Classic Connect 2 back while the B-7000 glue dries solid

Ocena
0 / 5
Polubienia
0
Pobrania
1
Wydruki
0
Wyświetlenia
52
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

Maybe the most niche possible print?

Background

I'd been having trouble glueing the iPod front plate into the Classic Connect 2 back evenly. For whatever reason I couldn't get the iPod front to sit flush with the Classic Connect 2 back on the top and the bottom.

I created this print to apply solid but spread-out pressure across the edges of the front and the back of the iPod to hold it firmly in place while the B-7000 glue dries.

It's designed to sit either side of the clickwheel in case you've done a hacky job like I have, and the clickwheel ends up sitting proud of the front plate.

Requirements

  • 4 x M8 nuts and bolts, minimum 40mm length bolt

How it works

  • Print 2 of the brackets

  • (Optional) Apply some felt, thin EVA foam or electrical tape to make sure you don't scratch the iPod with the bracket

  • Attach the two brackets together using the nuts and bolts, leaving a gap for the iPod. There's no threads on the print, it's just a clear passthrough that should fit M8 bolts (you might need to deburr the print slightly for them to fit)

  • Once you've applied the B-7000 glue, slide in the iPod to the gap, centering it within the brackets

  • Tighten gently with fingers (definitely don't use tools) to apply just enough pressure to hold the front and back flush together

  • Seriously, don't over tighten this, it should just be about the same amount of pressure you'd apply if you were holding it with your hands for 48 hours

  • Leave it for 48 hours for the glue to fully cure

Print settings

  • I printed it using PETG but I'm sure PLA will be fine, it's chunky and not under very much pressure

  • I used 2 walls

  • I used 30% infill

  • No supports needed

  • I didn't need any brims

I used the most ludicrously long bolts for mine because that's all I had. Let me know how you get on if you use this!

Tagi