Supernova E3 Tail (K915) mount v2 (for 50mm placing)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improvement geometry than v1 but a bit more difficult to print
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 44
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
This is v2 of my Supernova tail light. Absolutely different geometry for mount your light on flat surface.
v1 is here: https://www.printables.com/model/1750523-supernova-e3-tail-k915-mount-v1-for-50mm-placing
Get v1 if you want to print it easier and get v2 if you need specific geometry. Use thin hex wrench to clean inner channel. v2 also a bit longer (but v1 basement is wider).
v2 changes:
Now only 2 screws needed (vs 3 on v1)
Less contact area for better placing
New cable channel. Hidden or non-hidden cable management. Attention: channel is pretty tight for stable placing, please be sure the wire dont stuck or damage while you mount it.
Added small ring at the end of model for holding wire. Easier to drill surface for clean look.
I got bottom-wired version of light, but I also know about lights with wire on the back - and there is 10mm hole for mount it too. Unfortunately, I have not both versions, so if you can test this mount - it would be nice.
Use two M4 nylon lock nut (DIN 985) for mount light
DIN 7991 M4x12mm screws is the best choice for mount light but you can get longer if neccesary
Use DIN 912 M4 (x2 pcs) for mounting platform. Holes depth - 4mm.
Do not get too long screws because it would be dangerous for your tires
Using K915 light with bottom-wired version (as photo) you can drill additional hole for hidden cable management or use special wire channel for placing it above surface
Use screw locker or nylon nuts for prevent loosen during riding. Do not overtighten screws.
Hope it helps! Enjoy!