Flask Clasp Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The clasp of my flask that held its sprint loaded lid closed cracked and I designed and 3D printed a replacement.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 1
- Wydruki
- 0
- Wyświetlenia
- 96
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The clasp of my flask that held its sprint loaded lid closed is supposed to have two small lugs that hold it attached to bottle. These parts cracked and so when the bottle was open, the clasp just fell out. I went through 3 design iterations and designed and 3D printed a replacement clasp.
Printed in PETG on MKS4 0.4 with a mm nozzle with 100% infill as it takes quite a bit of load due to the springs and repeated motion. I used Prusa Slicer's variable width layers for finer control in the tiny parts.
This design of bottle seems fairly common model of bottle. So in case someone runs into the same types of problems, I'll publish the Fusion & STEP design files too :-)