Bitaxe Gamma 601/602 Vertical Upright Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just another simple stand for the Bitaxe Gamma 601/602 line of Bitcoin ASIC lottery miners. My boards came with decent…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
Just another simple stand for the Bitaxe Gamma 601/602 line of Bitcoin ASIC lottery miners. My boards came with decent 3D-printed stands already, but they assumed just flat desk placement and didn't have very good options for securing it to any surface. Because I was using wire shelving I decided to make this stand which has a few slots in the base that you can run zip ties through, screw them down, or create additional mounting accessories that interface with the slots. Basic design, open back, raised screw posts, to allow for as much natural air movement around the board still. I was able to use the original screws that came with my boards.
Tossing this up here for for whoever wants to use it, or feel free to remix it and make it yours.
I printed mine in ASA because I'm just obsessed with ASA right now. But any filament should be fine, just consider the heat depending on your environment.
Category: Electronics