Shark FlexStyle wall organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A shelf for the Shark FlexStyle body and its cabling, and another shelf for up to 7 accessories.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 44
- Wydruki
- 0
- Wyświetlenia
- 207
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Share Alike
My wife wanted hanging shelves for her Shark styler for easier everyday use. I designed 3 different parts:
Body holder
A simple U-shape and a recess for the main button that also helps the slippery body in place, with 2 prepared screw holes. The hook is optional for holding the mains cable in place.
Print settings:
Enable supports for the hook's slot as the hook is designed to fit neatly. Alternatively you can print without supports, but then you will need to do some post processing to fit the hook.
Default settings like: 0.2mm layer height, 15% infill, BALANCED profile.
Body hook
Just a hook extension for the body holder.
Print settings:
Print on its side for minimal support, but the V-shaped top needs supports.
Default settings like: 0.2mm layer height, 15% infill, BALANCED profile.
Accessory holder
My wife has 7 accessories (3 wider and 4 narrower ones). This object is quite large, but it should fit a Core One, or similar print bed diagonally. It also features 2 double-sided rings to save some space, and 3 prepared screw holes.
Print settings:
Print laying on the back plate with the screw holes.
Enable supports everywhere, they need to be put inside the rings. I used Snug style supports and they quite easy to remove with a plier, and a blade for the remaining tiny parts.
Use a slow profile like STRUCTURAL, this will add extra time but makes the rings much more circular.
Infill should be 20-25% to withstand being a relatively thin hanging shelf and regular push-pull of the accessories.
I also suggest using variable layer height and smoothing for much nicer surfaces in the rings. This can add 1-2 hours to the print time, so decide whether you want it.
I uploaded a project file with all these settings.
Sample ring
I also uploaded a sample ring if you want to try your print settings. I used these samples to adjust the ring size till it was good enough.
Print settings:
Stand on its side, add supports everywhere and a brim for more adhesion.
Otherwise use the same settings as for the Accessory holder above.