Shower Rod mount with tensioner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple, easy to print and install shower rod mount and tensioner for 1inch shower rods.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Share Alike
Replacing a shower rod mount and didn't find one here that doesn't damage or alter the walls/tiles at either end so I put this together. This is modelled for 1inch shower rods.
Designed an adjustable end to get the grip on the walls just right and included a slip-ring so that adjusting the end doesn't require the whole rod to spin.
Printing:
All the pieces except for the padding I printed in PETG which should work well here. The padding, I suggest TPU or anything flexible really.
Print 2 of the pads and one-each of the other models flat on the bed. I didn't use supports for the feet and just ignored the lesser finish there, knowing it'll not effect it's use with the pads pressed there.
Assembly/Use:
For the adjustable end, thread the foot into the thicker-walled end of the collar all the way. The slip ring sits into the other end and gets pressed against the rod in use. I suggest lightly rubbing a candle or some other wax onto the flat end of the ring (and perhaps the screw-threads also) for lubrication.
The stationary end just gets pressed onto the rod and with someone else holding the other end as you tighten the collar until it feels good and secure.