Emergency clutch lever for Triumph motorcycles (T-333 interface)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Going on a long roadtrip? Bring a spare emergency clutch lever for emergency use.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 75
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Emergency clutch lever for Triumph motorcycles with clutch wire.
Compatible with many Triumph models. Tested on my Street Triple 675 2015 model.
I have printed and tested this using PETG-CF filalment. It seems to be strong enough to last for a few days and a few hundred gear changes until you can get your hands on a replacement.
The use of a 3D-printed clutch lever can be dangerous, be prepared for it to break during stops when you hold the lever for a long time, at red lights etc. The consequence can be that your bike starts rolling into traffic. Be prepared to use the kill switch.
IMPORTANT; This clutch lever will NOT disengage cruise control. It lacks a small tap on the underside that engages a switch.
You still need to use the bushing from your existing clutch lever for the uploaded 3d-file. I might test and upload a variant without the need for the bushing.
You might have do some post processing on the holes for the clutch wire and the bushing. Depending on what material you use and how well calibrated your printer is.
Print settings:
Print with many perimeters (walls) and 40% infill. I printed this using 7 wall lines and a 0.6mm nozzle.
You want this part to be solid. Especially the area near where the clutch wire connects to the lever.
Print material: PETG-CF is more than stiff enough for the lever not to flex at 25C temperatures.
Print using supports.
Print orientation: Print with the flat side down.