Pegboard Mount for Hornady Lock'N'Load Bullet Tubes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A pegboard mounting solution for Hornady Lock'N'Load Bullet Tubes.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 61
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Public Domain
I designed this to fit my Hornady 9mm bullet tubes. I'm not sure if the .40 or .45 bullet tubes are the same diameter.
Mount on 1"-spacing pegboard using my Lockable Pegboard Rivet.
Holds three bullet tubes. Hornady sells them in packs of three.
Print in flexible TPU filament (95A hardness).
The Fusion 360 model is quite parametric. You can easily edit it for a different number of tubes, or different size of tubes. My Pegboard Mount for 8mm Primer Tubes is based on the same parametric design.
Printing Notes
I used gyroid infill, 20% density.
Turn on the "Avoid crossing perimeters" PrusaSlicer option (or the equivalent in your slicer). This helps to prevent the stringies, which TPU is notorious for.
Make sure your filament is bone dry. TPU is notoriously hygroscopic, and wet TPU is guaranteed to print badly. If you hear hissing and spitting from the nozzle, your filament isn't dry.
For TPU, I usually put down a layer of masking tape on the print bed. Otherwise, it's really hard to pull the print off.