1 / 7
Sparco Lawn Mower Hub Caps for Craftsman or for Honda — zdjęcie 1
1 / 7

Sparco Lawn Mower Hub Caps for Craftsman or for Honda

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Replacement hub caps for Craftsman 917.377842 and surely others.

Ocena
0 / 5
Polubienia
2
Pobrania
14
Wydruki
0
Wyświetlenia
148
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Update 7/22 - Broke the first hub cap off the other day, broke at the thinnest part of the mounting tube(?) I beefffed up the internal diameter of interfacing part for strength and then made the lip bigger since most of mine spin. Spinners would be dope but id rather they didn't. However, allowing them some free movement may even help prevent breakage so i uploaded a version 2 and 3 in case you are worried about a too tight of it. See file descriptions. 

Rice up your lawn mower with these Sparco hub caps for your Craftsman lawn mower. It felt fitting to match my mower rims to my CRX's since they are both honda powered and red. These are to model after Sparco FF1 rim. These fit my mower and i am sure many others but see the serial number and photos to make sure they will fit. I plan to add a bolted option for other newer mower wheels.  Internal of the snap part it 61mm and outer rim is 160.8mm. 

Printing - They may get messed up so dont go crazy. ABS or stronger is likely better but i printed in PLA and beefed it up. Yet to mow with them so we will see. Likely will regret but will print with ABS next time for sure. I only made 2 so far. 

  • 0.2 Layers, Normal supports set to snug, slow down on top surfaces as preferred, i set mine to 150mm/s. 4 walls and 30% infill are likely over kill. 

  • Fit varies, the 2 models had changes but none i believe that could change how tight they are but they fit slightly different. Front wheel is loser than rear, not likely an issue but we will see.  

Install - Remove old hubcap covers with a flat head screw driver, ignore the rusty bearings and simply give it a wack with your hand in the center to click it in. Instantly added 0.01 horsepower to your lawn hair cutting whip. 

Other variants to come. Happy Extruding!

Tagi