NR200 Top 3.5" Drive Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a model created to mount a 3.5" hard drive to the top of the power supply bracket in the nr200.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 993
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Public Domain
To mount this, you take out two of the power supply screws and put them back in through the mount to attach it to the psu shroud. Then you slide the drive in and screw it into place. Tolerances in this spot are very tight, you'll want 90 degree sata connectors to get the drive to slide all the way back. One top fan can still be used with this setup. Finally, the drive blocks access to the psu power switch, so make sure it's on before you screw in the drive, otherwise it can still be switched on and off with a thin object like a toothpick. I printed it using a Creality Ender 3 Pro in black PLA filament with supports turned on and no raft. Print time was 3 hours 38 minutes.