'Get Bent AFG' Remix for Mac N Cheese

Remix of the FFFTechnology “Get Bent Stubby AFG” modeled to fit the Mac N Cheese.

What's changed:

1. Attachment area was made smaller to only cover the three 1913 slots on the Mac N Cheese front receiver without bottoming out against the back. 
2. Applied the “textured” variant pattern to the bottom half.
3. Recreated the contours of the grip (not by choice--couldn't split the attachment area off without destroying the original curvature). However the “knuckle” is now much less visible.
4. Made grip area larger. Grip is 4mm wider and ~3mm taller.
5. Offset 1913 interface walls very slightly to allow for easier installation without having to wack it onto the rail, especially if printed with “fuzzy skin” setting.

Check out FFFTech for all of their great designs.

Notes from original model:

Installation

1. Press the M5 hex nut into it's indexing socket.
2. With the hex nut installed, slide the forgrip onto the rail and align the bolt channel with
     the preferred rail slot of installation.
3. Drive the bolt through the channel and start threading into the hex nut.
4. Tighten the bolt into the hex nut until the foregrip is mounted firmly in place. The end of 
     bolt shouldn't protrude past the hex nut indexing slot. Avoid overtightening the bolt. 

Print instructions

• Print Settings:
  • Extruder: 204C 
  • Bed: 56C 
  • First Layer Print Height: .20mm 
  • Standard Layer Height: .14mm
  • Wall Thickness: .40 
  • Wall Perimeters: 3 - 4
  • Infill: 20%
  • Infill Pattern: Gyroid
  • Material Flow: 100%
  • Support Material Percentage: 18%
• Print upside-down, using support material only for the rail slot.