Lamp base for 45mm pre-wired socket - 2w bulbs or less!
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A lamp base I made as for first project in FreeCAD. Includes the fcstd file.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 67
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution — Noncommercial
Was created to be used with https://www.amazon.com/dp/B0CHHVSLQ1 but should work with any lamp kit that uses a 6mm or smaller diameter cord, and has a 45mm socket base.
This was intended to be a reference for me to make a wooden version, as even high-efficiency, low-wattage, LEDs can get very hot, so plastic is not the ideal material for this. Please do not use with bulbs that draw over 2 Watts if printing as-is!
If planning to ignore my warnings and use this as-is and/or with higher wattage bulbs, please make sure you're at least taking proper precautions to dissipate heat, and use a heat-resistant material that will not cause toxic fumes if the worst were to happen.
The FreeCAD files are available as well, but fair warning, while this is parametric, this was my first FreeCAD project, and the parameters aren't setup properly. The parameters are setup as properties of various sketches, and the spline is mostly unconstrained and must be adjusted manually.
Please let me know if there's anything else I've done horribly wrong in the CAD, or if you have any constructive feedback. :) I'm still learning, but am always happy to learn more!
Created using FreeCAD V1.1.1