Elegoo Centauri Carbon Canvas Shroud/Lower Mount Remix CC1 for Top Cover / Riser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed Lowered Canvas Mount and New Shroud. Remix of @PrintedRawDs_4927914 CC1 and CC2 Lowered Top Cover.
- Ocena
- 4,857 / 5
- Polubienia
- 115
- Pobrania
- 566
- Wydruki
- 6
- Wyświetlenia
- 4797
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
@PrintedRawDs_4927914 Centauri Carbon 1 and 2 lowered top cover/riser remix. I like his design since it lowers the canvas to make the height of the top hat/cover/riser much lower. Also the acrylic is very affordable and easy to get. Total cost $13 (qty6 acrylic, no cutting) + less than 1kg filament.
The only issue I had with the original model is the use of the rotating PTFE passthroughs. This kept the PTFE tubing at a set height/angle/position through the riser. Because I am using a dryer this caused the PTFE tubing to have too many tight bends to the printhead. This did cause printing problems for me. If you have the spools hanging on the sides of the printer, I believe you will not have the issue I had and his design should work well.
To solve this issue, I remixed/redesigned the canvas mount and designed a shroud to work with his design. I designed it to have a good fit with his design and the top of the Canvas. You will NEED the CC1 spacer from @PrintedRawDesig original design to mount this remixed Canvas mount.