Power Rangers Ninja Storm Lion Hammer

Print Settings

• Sonic Fin

  • Wall loops: 2

  • Layer Height: 0.2mm

  • Infill: 5%

  • Sparse infill pattern: Gyroid

  • Support

    • Default: tree

    • Special cases: normal

      • back_screw_pt1

      • hammer_face

      • hammer_neck

      • handle_short_pt1

      • handle_short_pt2

  • Brim type: Outer brim only

    • I only used this for the extended handle parts

Printing Instructions

Printing is very straight forward. Arrange the pieces however you like. There are a few pieces that need to be duplicated. If you're printing the version that can combine, then be mind full of the indicator in the back screw. There is an arrow on the back to help line it up, otherwise it's a little confusing. You will want to adjust or pad the connectors with a bit of masking tape. I left them a little loose to accommodate for different post processing flows.

There's only one part where the orientation may not be obvious. For handle_pt1 you'll want to orient the smaller side on the bed. Since you'll be screwing into this part, printing in this orientation makes sure that the top layers for the screw holes are better supported by the plastic.

• logo

  • Print 4 for each handle version

• handle_pin

  • Print 10 for the extended handle

  • Print 5 for the folded handle

• cylinder_pin and square_pin

  • Print each 3 times

IMPORTANT: When forming the Storm Striker, make sure support all the pieces as best as you can. Depending on how you print them, as well as your finishing process, there will be a bit of weight on the connection points. It's 3D printed at the end of the day so be mindful of that.

Assembly

All links are non-affiliate

Parts list

• 3 Strong neodymium countersunk magnets 

  • The cutouts are specific to these measurements in-case the linked magnets are no longer available

    • Steel pad (thin magnet)

      • 0.63 inch (16 mm) diameter

      • 0.08 inch (2 mm) height

    • Cup magnet (thicker magnet)

      • 0.63 inch (16 mm) diameter

      • 0.19 inch (5 mm) height

• 3 M3x10 mm countersunk screws

  • The magnets should come with screws, but this is the measurements just in-case

• 4 20x5x2 mm Strong neodymium magnets

  • This is for the cover

• 1/2 inch wooden dowel or carbon fiber rod cut to ~26 inches (~660 mm)

When placing the magnets, the larger of the magnets goes into the head. It's important that both magnets are able to touch to have a secure connection. Personally I only have a magnet in the first and third spaces, leaving the middle empty. There's no real reason for that, it felt pretty secure that way so I left out the 3rd.

Height Extended (top of hammer face to end of handle): ~34 inches (~856 mm)

Height Folded (top of hammer face to end of handle): ~8 inches (~210 mm)

Length (front of hammer face to back of screw section): ~11 inches (~290 mm)

The full model is also included for scaling, or slicing up yourself, as well