1 / 1
Toyota Aygo Washer Cap Upgrade: you've already lost the original one, haven't you? — zdjęcie 1

Toyota Aygo Washer Cap Upgrade: you've already lost the original one, haven't you?

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The original Aygo cap keeps escaping. This TPU version stays exactly where it belongs. Upgrade complete.

Ocena
0 / 5
Polubienia
0
Pobrania
14
Wydruki
0
Wyświetlenia
80
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Automotive
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

There's a silent defect on the Toyota Aygo that no recall bulletin has ever mentioned: the windshield washer reservoir cap comes off. Not always, not right away, but sooner or later it flies off, on the highway, in a parking lot, into the cosmic void, and at that point you're left with an open reservoir and a hole in the engine bay that screams "abandoned car in the desert."

This model is not just a replacement part: it's a genuine upgrade. Printed in flexible TPU, the rubbery material creates a natural friction against the reservoir neck that the rigid original can never replicate. It screws on just as easily, but once closed it stays there, firm, immovable, completely indifferent to engine vibrations and potholes courtesy of your local municipality.

Tested directly on a real vehicle: it fits perfectly, holds the fluid in and, most importantly, doesn't go wandering off on its own. After years of losing original caps on the road, this is the definitive solution that costs less than a cup of coffee and prints in under an hour.

🧩 Print Specifications
- Layer height: 0.16 mm (more precise than the original threading, and a lot more loyal)
- Infill: 15% Gyroid (solid yet flexible, exactly what you need from a cap that actually holds)
- Supports: no (designed to print without supports, just the way everyone likes it)
- Brim: yes (recommended to ensure perfect adhesion to the print bed)
- Material: TPU 95A black (the secret ingredient: rubbery, resistant, and it doesn't run away)
- Print time: about 1 hour (less time than it would take you to find a replacement one online)
- Filament used: about 12 g (little enough that you can print a backup stash for the next ten years)

⚠ Compatibility note: this cap has been designed and tested on a Toyota Aygo. Before printing, please verify compatibility with your specific model and year of production. Reservoir neck dimensions may vary between different versions and model years.

Print it, screw it on, and forget about it: this time the cap stays where you put it.

Tagi