Granite Surface Plate Feet & Alignment Jigs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Granite Surface Plate Feet & Alignment Jigs
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 27
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution
Granite Surface Plate Feet & Alignment Jigs
Printed the feet out of SainSmart TPU. You will most likely want four of these.
https://www.sainsmart.com/products/gt-3-flexible-tpu
Printed the Alignment Jigs out of Tough Pro PLA+, but any PLA should work.
https://www.3dfuel.com/products/pro-pla-filament-lulzbot-green-1-75mm
Used Clear Gorilla Glue to glue TPU feet to granite plate. Don't allow the PLA jigs to be glued to the plate. Remove them after gluing and placing TPU feet in place. I used blue painters tape to hold the TPU feet in place while glue was drying. I also put a smaller granite plate on the TPU feet to make sure they remained flat until the glue dried.
I cleaned the granite plate with Acetone many times until white towel was clean and no more residue or oils came out of the plate. Be cautious with Acetone. Wear proper personal protective equipment. Don't do this near open flame or heat source.
https://www.homedepot.com/p/Gorilla-1-75-oz-Clear-Glue-4500100/301050930
I also included the STEP files for those that want to edit or play with the design...