1 / 2
Flashforge Adventurer 5M Nozzle Fan Cover (to change its high pitched squeal) — zdjęcie 1
1 / 2

Flashforge Adventurer 5M Nozzle Fan Cover (to change its high pitched squeal)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Another variation of the famous cover for the nozzle fan to reduce the high-pitch noise.

Ocena
0 / 5
Polubienia
5
Pobrania
36
Wydruki
0
Wyświetlenia
169
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

After seeing a couple of models [1] of covers to improve the noise generated by the fan to cool the nozzle, I decided to make my own version because I didn't like the way those were affixed (either with double sided tape or with a big bracket across the extruder assembly).

This version is held in place by one of the screws for the filament feeding assembly. With this piece, the screw is limited in its travel by just 0.25mm, so I doubt it has any negative effect; in any case, I have not had faults after installation.

I have printed the part in PETG using the "fine" preset and Arachne wall generator in OrcaSlicer. The cover is designed to be printed with the flat surface facing down on the plate, and there is no need to use supports.

P.S. If there are imperfections on the surface of the cylinder, it might be necessary to file the part slightly for it to fit in the recessed area for the screw.


[1] The models that inspired me:

Tagi