1 / 1
Voxelbenchy: the only ship that mines your patience too — zdjęcie 1

Voxelbenchy: the only ship that mines your patience too

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

All cubes, all 90-degree angles, zero soft curves. Sturdy as a real stone block.

Ocena
5 / 5
Polubienia
5
Pobrania
12
Wydruki
1
Wyświetlenia
60
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution — Noncommercial — NoDerivatives

Some people spend hours digging tunnels, building fortresses and stacking blocks on top of each other without much structural logic, and some people take that exact aesthetic and turn it into a fully voxelized Benchy. The result is this squared-off ship that looks like it came straight out of a procedurally generated world.

The hull is built entirely from light wooden blocks, stacked in clearly distinct horizontal layers, with that grain texture typical of pixelated wood. The cabin and the upper rim are reinforced with grey stone blocks, crenellated like a small defensive fortress, because even voxel ships need to feel safe from any nocturnal creatures lurking nearby.

The chimney follows the same stacked-block logic, while the entire structure strictly keeps to 90-degree angles: no curves, no compromises, just pure geometry made of cubes that, put together, still produce the unmistakable silhouette of a Benchy. A small square porthole on the side completes the look, just a reminder that even in a blocky world, a little extra detail always helps.

🧩 Print Specifications

  • Model height: 150mm (taller than a tower built right before night falls)

  • Layer height: 0.16 mm (more precise than placing a single block with a right-click)

  • Infill: 10% Lightning (hollow inside like a cave dug out by hand)

  • Supports: yes (even the sturdiest structures sometimes need a prop)

  • Brim: optional (just to keep the base from running off like a chicken escaping the pen)

  • Material: PLA matte white (later painted in light wood and grey stone tones)

  • Print time: about 10 hours (way less time than it takes to find diamonds down in the depths)

  • PLA used: about 210 g (light as a block of sand, but a lot more stable)

🖌 Recommended painting technique

after applying the spray primer, lay down a light wood/beige base coat with acrylic marker over the entire hull, then add slightly darker horizontal lines freehand to simulate the blocky wood grain. The cabin and crenellated edges should be painted light/medium grey, with a light dry brushing pass in darker grey over the edges to bring out the stone effect. The square porthole should be dark grey/black for depth. Keep clean, sharp lines everywhere, avoiding soft blending: this model's strength lies precisely in the crisp contrast between blocks, so feel free to use masking tape for precise edges if needed. Fully matte finish, zero gloss.

Print it, paint it, and place it with care: one crooked block and you'll have to start all over.

Tagi