Mill or Grafting Knife Handle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3/4" Grafting Knife handles - fits blanks such as the ones from Hyde tools. Work in Progress
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 389
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted a knife handle that'd work OK for a 3/4" mill blade "blank" such as the ones from Hyde tools. This is a work in progress, so beware. I plan on iterating over this design a bit as I see any shortcomings play out while I graft things with it, after profiling the dull side of my Hyde blank to a 20 degree single bevel edge.
I plan on using a slow-setting epoxy to set the blade in the handle. Keep in mind that you may need to scale up a part by an additional small % in order to account for shrinkage and the knife blade fit depending on your print settings. I made several handle variants depending on what kind of blade you have and handle for it that is needed - you can:
-Print parts A+B and epoxy it all together with the blade in, clamp it all down tightly and let it cure together for a while
OR
-Print part "D" solo and stick the blade into the handle with epoxy already inside the part, and then let it cure together for a while. You will probably need to scale up part D by an additional small % in order to account for shrinkage depending on the handle material you use and your printer settings. It's a bit easier to slide the blade into the handle while the part is still warm and hasn't contracted from cooling
OR
-Print part "E" solo WITH SUPPORTS (since it is a rounded handle on both sides), lightly sand where the supports were detached, stick the blade into the handle with epoxy already inside the part, and then let it cure together for a while. You will probably need to scale up part E by an additional small % in order to account for shrinkage depending on the handle material you use and your printer settings. It's a bit easier to slide the blade into the handle while the part is still warm and hasn't contracted from cooling
Please be careful with knives and pointy things. I take no responsibility for anything going wrong during the course of using or printing these knife handles..
Print Settings
Printer:
Artillery
Rafts:
Doesn't Matter
Supports:
No
Infill:
30
Category: Hand Tools
Atrribution: Shout out to Hanleypc on thingiverse, for the original 2 piece knife handle model that mine is loosely based on. https://www.thingiverse.com/thing:3996044