Chicken Waterer base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a base or stand for a chicken waterer - the kind with a little red cup at the end that shuts off the valve
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 1457
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
This is a base or stand for a chicken waterer - the kind with a little red cup at the end that shuts off the valve when it's filled with water, such as the "Automatic Fill Chick Cup Drinker Waterer" from RentACoop
I didn't have a good surface to attach the waterer to the side of the brooder I'm using, so I wanted to print a stand for it that'd make the waterer much less prone to tipping over, while also raising it off of the floor a little bit so the bedding can't interfere with the clearance of the cup (which causes issues keeping a steady amount of water in the cup)
Keep in mind you WILL need to scale the model to your appropriate sized waterer - since my waterer base was about 4" x 4" I scaled the model in Cura to about 130mm X 130mm X 80mm and it worked great for my size waterer.
Print Settings
Printer:
Artillery Sidewinder X1
Rafts:
Doesn't Matter
Supports:
No
Infill:
10%
Filament: Hatchbox PLA Orange
Notes:
Feel free to remix this as I feel that the walls could be voided out more so that the print uses much less plastic. I like to use cubic subdivision infill
Category: Pets