USBtin D-SUB case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a case for the USBtin (https://www.fischl.de/usbtin/) CAN bus USB adapter. The design is intended to protect…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 435
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a case for the USBtin (https://www.fischl.de/usbtin/) CAN bus USB adapter.
The design is intended to protect the PCB and at de same time adapt to the widely used D-SUB connector.
The lid should click in place nicely but is not intended to be totally tight.
I used two M2*4 self tapping screws to fix the PCB in place. For the D-SUB connection you will need a standard panel mount female d-sub connector socket and matching mounting bolts.
Then just solder the CAN wires to the D-SUB interface and use the screw terminals to connect to the USBtin.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
20 %
Filament: DasFilament PLA transparent
Notes:
Supports are not needed for the lid.
Depending on your printer you can also print the bottom part it without supports, but I would recommend them to get nice openings for USB and D-SUB.Category: Electronics