1 / 6
Filamentdurchführung MMU3 für Enclosure / MMU3 Filament Feed Unit for Enclosure — zdjęcie 1
1 / 6

Filamentdurchführung MMU3 für Enclosure / MMU3 Filament Feed Unit for Enclosure

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

MMU3 Filamentdurchführung für Enclosure. / MMU3 Filament Feed-Through for Enclosure.

Ocena
0 / 5
Polubienia
1
Pobrania
3
Wydruki
0
Wyświetlenia
73
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
GNU General Public License v3.0

Er handelt sich um eine Filamentdurchführung für das Encolsure des MK4s mit MMU3. Diese wird durch die Rückwand des Gehäuses gefürt. Heitzu muss ein Auschschnitt und 6 Löcher gebort werden (es ist praktisch die Rückwand abzukleben, um Beschädigungen zu vermeiden).Außerdem muss in jedem Loch der gedruckten Komponenten ein M5 Gewinde Nachgeschnitten werden.

Benötigt werden:

6x M3 Schraube (ca. 9mm länge (8mm))

6X M3 Vierkantmutter

10X Pneumatikanschluss M5 auf 4mm Schlauch (Innendurchmesser ca. 2,6mm nicht 2,5mm!!!).

///

This is a filament feed guide for the MK4’s Enclosure with MMU3. It is routed through the back panel of the enclosure. To install it, you’ll need to cut out a section and drill 6 holes (it’s a good idea to mask off the back panel to prevent damage). Additionally, an M5 thread must be cut into each hole in the printed components.

You will need:

6x M3 screws (approx. 9 mm long (8 mm))

6x M3 square nuts

10x M5-to-4 mm pneumatic fittings for tubing (inner diameter approx. 2.6 mm, not 2.5 mm!!!).

Tagi