Mini-Filament-Masterspool
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
It´s basically just a remix of the beautiful Honeycomb Filament Sample Spool from kszlachcikowski. The differences are: It prints faster, it has an integrated Filament clip (which doesnt bend the filament too much) and an integrated label.
I also added a Winding tool.
Print instructions:
- 0,2mm layer height
- good first layer recommended
- about 20% infill, I used aligned rectilinear
1 Top + 1 Bottom (50g or 100g) = 1 Spool
How to use the winding tool:
Put one end of the filament through one of the winding guides.
Insert the filament spool into the tool, and the filament tip into the spool.
put the spool with the tool on a Table like that and make sure they´re aligned like this
now hold the winding tool and spin the filament-spool to wind up the filament.
(the spool doesnt always spin easily, you might need to add a little bit of force)