1 / 9
FKD 13×18 Back plate for Modern Plastic Film Holders — zdjęcie 1
1 / 9

FKD 13×18 Back plate for Modern Plastic Film Holders

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Back plate for wooden large format camera FKD 13x18 adapted for Plastic Film Holders

Ocena
0 / 5
Polubienia
3
Pobrania
2
Wydruki
0
Wyświetlenia
50
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Photo & Video
Licencja
Creative Commons — Attribution — Noncommercial

I own a 1958 FKD 13×18 large format camera made in Kharkiv. It was originally designed to use old wooden film holders. Recently, I purchased several newer plastic FKD film holders, but unfortunately they did not fit my camera. It turned out that these holders are slightly larger than the original wooden ones. To solve this problem, I designed and printed a replacement back specifically for this type of holder. It should be compatible with early FKD 13×18 cameras.

Requirements

  1. 2 × M3 × 10 mm screws
  2. 2 × M3 heat-set inserts (4.5 × 3 × 3 mm)
  3. Ground glass, 138 × 178 mm, 2 mm thick
  4. 2 paper clips made from 1 mm wire
  5. Approximately 160 g of PLA or PETG filament

Assembly Instructions

  1. Print all small parts first. You must haveLock_Part-1 ready before printing the main frame body.Important: Donot glueLock_Part-1 andLock_Part-2 together at this step
  2. PrepareBack_plate.stl for printing and add a pause in your slicer at the layer shown in the screenshot
  3. When the printer pauses, placeLock_Part-1 into its designated slot and resume printing
  4. PrintGlass_holder
  5. To connectBack_plate andGlass_holder using theHinge, I used ordinary paper clips straightened with pliers
  6. Install the heat-set inserts intoGlass_holder using a soldering iron
  7. Install the ground glass and assemble all parts together

Category: DIY

Tagi