Kingdom Death: Monster - Gear Grid Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holder of gear grids for the Kingdom Death: Monster board game.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 154
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Here is an organizer for gear grids with some bonus space for more dice.
Note this is designed to have three models stack, using magnets. The Gear Grid holder, Large Terrain Tiles Holder, and Black Knight Terrain Tiles all work together:
SLEEVES - I sleeved my gear grids using these sleeves:
The only catch is the sleeves are too short by 1/4". What I ended up doing was trimming 1/8" off the top and bottom of the grids with my paper slicer and they fit perfectly. There is enough of a margin around the grids to not be a problem. Note: The scout gear grid had to be trimmed on all four edges.
MAGNETS - They are 5mm diameter x 2mm high cylinder magnets. I'm using N52 magnets, which I believe are the strongest you can get.
I ended up having to glue the magnets as they will eventually pop out over time. I used Zap-A-Gap Medium CA+. I found that it does very little ghosting on the print. I use a chopped off toothpick(so it isn't pointy) dipped in the glue to apply it.
PRINTING - What's shown in the pictures was printed on a Prusa XL in an enclosure with Prusament Galaxy Black. Print settings, 0.4mm nozzle, 0.2mm layer height.
Also note the pictures are a lot lighter because my phone auto adjusted exposure. In real life they are a much darker black.