Great White Shark Earring Charm — Bites the Ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A realistic sleek great-white shark charm that bites a jump-ring held in its mouth.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 46
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Fashion Accessories
- Licencja
- Creative Commons — Attribution
WARNING — the fins are very brittle. Handle gently.
The dorsal, pectoral and tail fins are thin and snap off easily — both during support removal and in normal handling. Please be careful:
Remove supports slowly, supporting each fin with a finger.
For stronger fins, print with 3+ walls, slow the outer-wall speed, and consider PETG or tough PLA instead of brittle PLA.
This is a delicate display / jewelry charm, NOT a toy for rough use.
A realistic sleek great-white shark charm that BITES a jump-ring held at the front of its mouth. The ring is the hang point — worn upside-down, the metal earring hook threads the mouth-ring and the shark hangs nose-up / tail-down.
About 37 x 66 x 25 mm, single watertight body.
A jump-ring (2.5 mm inner, 5.7 mm outer) is fused into the front of the jaws, hole running side to side so the profile faces forward.
Add a fish-hook ear wire through the printed mouth-ring for an earring, or a lobster clasp on a chain for a pendant.
Print:
Print on its SIDE (flat profile on the bed) with tree supports for the fins and jaw, or belly-down with a brim.
0.12 mm layers for crisp detail, 3+ walls, 15-20% gyroid infill.
Counter-shade it: print or paint slate-grey on top, off-white below.
Remember: the fins are fragile. Strong walls + a tough filament make a big difference.