Foldable Phone Stand REMIX (Bottom pulling tab + Bottom reinforcement)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This tested remix adds a pulling tab & reinforcement solely to the bottom part and its two hinges. 86% size. Resizeable
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 115
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The original remix by Ozzy The Artist, though mostly sturdy when deployed, lacked a way to open up the bottom part on which the bottom of the phone rests without lifting the phone stand and pushing it open with your finger. I added a pulling tab to that part so that you can pull it up after placing it on a table - a useful feature if the part falls closed. It makes opening that part less fiddly.
Additionally, the hinges of the bottom part were too thin. I added material to them to thicken them, greatly increasing the force required to break them. I printed the model and confirm that the reinforcement does not merge with the interior hinges. The original range of motion of the hinge is also not changed.
Shrunk the model to 80 mm wide x 120 mm deep x 5 mm high. Can be rescaled in the 3MF file.
Note: A small chamfer was added to the bottom reinforcements post-print. You can edit it and the other modifications in the 3MF file.