VibeStop - BambuLab A1 Anti-Vibration Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Effectively cancels the transmission of vibration from one printer to another. No more spool unwinding when idle.
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 169
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
When you have two printers on the same table and one is running while the other is idle, you are in danger of slowly unwinding the idle spool due to the transmission of vibrations from one printer to another. See picture.
It's really amazing to see the printer wiggle. Unfortunately, printables.com won't let me upload a video of them working. You can watch a short clip on my mastodon page:
https://mastodon.social/@MuthesiusAssemblyWorkshop/116804706969889159
These anti-vibration feet do not use rubber material but instead rely on 8mm steel balls (from old bearings) that rest in small bowl-shaped cavities, so that every printhead/bed motion will cause the machine itself to move, rather than shake the table. Glue the upper bowls to the printer's bottom side (i used double-sided adhesive tape) and stick the bottom bowls to the table. You can print the Placement Guide part (twice) for precise bowl alignment. Don't forget to repeat the printer's vibration calibration routine after installation.
For maximum bowl smoothness, print them upright (standing on the side) in high quality with 3-4 wall loops. No support needed. Prefer rather tough material like PETG or even Nylon for longevity, but PLA will also be fine for a while. 8 pieces needed for one printer (you could try to get away with 6, though).