Weller WT13EU blowtorch slider and trigger
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Weller WT13EU blowtorch replacement slider and trigger
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 2
- Wydruki
- 0
- Wyświetlenia
- 14
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Share Alike
Be careful when disassembling/reassembling the torch, to not break or leave gas lines open!
The original internal slider part of the trigger broke on my blowtorch shortly after purchasing, after it fell off my desk. As I didn't want to spend ~40€ again, the obvious choice was to try to fix it.
So after a few test prints to get everything to fit, move and not break from the force required, this is the final version that has lasted for a long time now. I used Phaetus ASA-GF for my prints.
Requires additional hardware:
2x M2x3.0 heat inserts (i used these ones from CNCKitchen)
1x M2x6 and 1x M2x12 DIN912 bolts (alternative model provided for 2x M2x6 only)
This is actually something I made in 2024. I just forgot about it as the Fusion model list got longer.