Interior Floor Drain Cover — 7" Round Flush Mount (Drop-In / Silicone Set)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Custom 7" round flush mount floor drain cover. Drop-in design, silicone compatible. Covers large interior drain openings
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 83
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Public Domain
This is a custom-designed flush mount floor drain cover for large interior drain openings. The cover sits flat against the tile or surrounding surface and can be permanently set in place with a bead of silicone for a clean, finished look.
Designed for situations where a standard off-the-shelf drain cover doesn't exist or doesn't fit — common in older homes, custom tile work, or renovations where the drain hole is oversized or non-standard.
Features:
7" outer diameter, ¼" tall — low profile flush mount
Flat outer flange rests against tile or mating surface
Rows of rounded rectangular slots allow water flow while covering the opening
Compatible with silicone adhesive for permanent installation
One-piece print — no hardware needed
Printing Recommendations:
Layer height: 0.2 mm
Infill: 30% (gyroid or cubic recommended)
Walls: 3
Filament: PETG recommended for moisture resistance
Supports: Not required
Orientation: Print flat, face-up
Installation:
Test fit the cover over your drain opening
Apply a bead of silicone around the underside of the flange
Press into place and allow to cure per your silicone manufacturer's instructions
Notes:
Designed for interior use on tile or finished flooring surfaces
Verify the drain opening is smaller than 7" before printing