1 / 2
Spacer for Noctua NF-A12x25 G2 (120 mm) and NF-A14x25 G2 (140 mm) fans — zdjęcie 1
1 / 2

Spacer for Noctua NF-A12x25 G2 (120 mm) and NF-A14x25 G2 (140 mm) fans

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A spacer for Noctua NF-A12x25 G2 and NF-A14x25 G2 fans designed to reduce the noise when mounted on meshes and grids.

Ocena
0 / 5
Polubienia
1
Pobrania
12
Wydruki
0
Wyświetlenia
133
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A spacer for Noctua NF-A12x25 G2 and NF-A14x25 G2 fans designed to reduce the noise when mounted on meshes and grids. In those cases, additonal noise is created by the fan blades passing close to the grid or mesh. This especially affects the inlet side of the fan. These spacers put some distance between the blades and whatever sits in the flow path, which reduces the noise.

The design is available with two different alignment pins (thin or thick), as well as without any pins. The "No Pins"-version should work on pretty much any 120/140 mm fan - doesn't have to be a Noctua. Four thicknesses are provided for each layout: 1, 2, 5 and 10 mm. I recommend to go with at least 2 mm of thickness for a noticeable reduction in noise, 5 mm will perform much better.

PLEASE NOTE: The thin pins did not print well in TPU on my printer which uses a Bowden extruder, but they do work and will likely come out fine if your printer uses direct drive (-> essentially all modern printers). The 120 mm version for the NF-A12x25 G2 is untested.

Print settings

  • Layer height 0.2 mm

  • Line width 0.42 mm

  • 2-3 wall lines

  • ≥4 top and bottom layers

  • Supports not required

Material must be flexible / TPU. The design was printed and tested with TPU 95A. If you want additional isolation from vibrations, a softer TPU like 85A might work better.

Approximate print time @ 30 mm/s: 1:45 h (2 mm version for NF-A14x25 G2)

Tagi