CFMOTO 800 MT-X Oiler Mount Project
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CFMOTO 800 MT-X Oiler Mount Project
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 3
- Wydruki
- 0
- Wyświetlenia
- 123
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Have a nice day, everyone!
First of all, this project is more about how to mount an oiler on the 800 MT-X than a solution that will fit everyone.
I originally designed it for a PDOiler that had been used on a V-Strom since 2018 (if I'm not mistaken) and moved to BoomTrix less than a month ago.
In case you have another oiler brand, you can design your own VolumeMount*.stl.
Use PM if you lack modeling skills. I would try to make simple adjustments to the original model, but I cannot guarantee that everything will fit after modifications.
Installation is quite simple and requires:
DIN912 or DIN933 M6x30-35 (x2)
Plastic ties > 6mm (x3)
I personally used DIN912, and it was quite a thing to tighten them up, so I recommend using DIN933 instead.
You can print VolumeMount* however you like.
I tested horizontal and vertical prints — the strength is the same, but the vertical orientation may look better, depending on your printer cooling performance.
A few words about the 1000 MT-X.
I guess this model will fit, cause the subframes are the same, but I cannot guess the required fastener sizes cause the mount is occupied by the shock adjuster.
In my opinion, you can use longer bolts to mount the adjuster and M6 nuts to fit the oiler mount.