125mm 5 inch vent cover
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Vent for 125mm or 5 inch ducting,.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 51
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
This vent cover has a screw in grill to make cleaning easier. It is intended for mounting under eves/soffit or inside the house, I would not use it where it would be exposed to direct rain with wind unless you fit some sort of cover. It has raised parts on the screw in grill to make it easy to screw in or out.
I printed in PLA with 15% infill no supports (PLA was the only white I had) , Ideally I would have used ABS or ASA as I think PLA will tend to yellow or become brittle over time in an exterior application, even under a soffit.
Key printing concepts: I scaled the screw in insert to 99.5% on X and Y axis only (not the Z axis). this allowed for plenty of clearance and made it easy to screw in.
Last Comment, it will reduce airflow slightly as compared to factory ones with clip in grills as the thickness required for threads reduced the outlet/inlet air area (depending where you are using it).