10 inch rack mount for TP-Link ER707-M2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A method to force this wide router into a 10 inch rack.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 254
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
The TP-Link ER707-M2 router is just slightly wider than a 10 inch rack slot. This design is one way to mount the router in a 10 inch rack with a serviceability trade-off. It takes an opening of 4U to insert/remove the router using about a 45 degree angle before bringing horizontal. After that, it consumes 1U in the rack. Just plan what goes adjacent to the router for easier serviceability.
Despite the in-out process, this does allow for a clean look and functional install in a common 10 inch rack. The router is recessed back slightly and sits behind the vertical rails of the rack. This was installed in the Tecmojo rack, but it should also fit the GeekPi 10 inch mini rack as well.
See the photos for more description. Hopefully, some day TP-Link will adopt their products to fit the 10" rack standard, but until then hacks like this will be needed.
I printed face down with normal supports to preserve the 2.8mm slot dimensions. I used PETG due to potential heat from the router.