1 / 3
Bilge Pump Head
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
A friend had a vintage boat with a manual bilge pump. The original “Head” was made out of a hard rubber, it had deteriorated beyond repair. And there were no replacement parts available.
There is a flare at the top of the brass body so I designed it with a split threaded base. It was also designed to use a flat gasket at the top of the flange for a seal. This seal was not needed as leaking was minimal, and it is being used in an inherently wet environment.