Core One L Chamber Heater
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Chamber Heater using the Creality Chamber Heater on the Left Side of the printer
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 220
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
I created a new panel to replace the upper left panel of the Core One L to fit the Creality Chamber Heater.
If you want to use it on the right hand side, you should just need to mirror the parts. I can not confirm this because I use @TheNexusAvenger "BentoRoll" Recirculation Filter in the right hand panel.
You can use the three M3 screws that came with the heater to mount the heater in the box. You will need to remove the silicone outer cover to get the unit in the box. Start with the wires and slowly rotate the unit in. It will be very tight, but it does fit. DO NOT force it.
When inserting the fob, it is very much a tight friction fit. Take your time and work it in. If you want a looser fit, you can sand the top and bottom a bit with some 220 grit and make it easier.
You will need eight M2 3mm deep heated inserts with matching screws and washers no longer than 8mm long for the wire gasket and cap.
You will need four M3 heat inserts with matching screws, two 8mm long and two 16mm long for the fab bars.
To combine the 3 panels into a single monolithic panel I beveled the mating edges so you can use left over filament and weld the panels together with a flat tip soldering iron.
To attach the panel you will need four M3 6mm long with washers and nuts and 12mm long but no longer than 14mm long with nuts and washers for the front two holes where the fob mount secures. You will reuse the panel clip on the rear bottom for ease of installation. I didn't want to fight to try and get a nut and washer back in that corner.
To aid in the installation of the Fob mount I used three 6mmx3mmx1.5mm magnets to hold it to the frame while I got the screws though the Fob mount, panel, and corner frame of the printer.