Geometric Handle Upgrade for Anycubic ACE 2 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Do you want a custom colour for the handle or do you just not like the original design? Then this is for you!
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 307
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The update on 19/07/2026 improved the design and strengthened the locking mechanism.
Custom Handle for Anycubic ACE 2 Pro
Give your Anycubic ACE 2 Pro a unique look and better ergonomics with this upgrade handle!
Do you want a custom colour for the handle or do you just not like the original design? Then this is for you!
Print Settings & Recommendations
Material: PETG recommended for better durability, PLA should work fine as well.
Supports: Yes, supports are required.
Orientation: The handle was specially designed to be printed as easily as possible at a 45-degree angle. I highly recommend printing it exactly in the orientation provided in the attached
.3mffile.
Installation / Removal Instructions
You can remove the stock handle without damaging it by following these steps:
Take a small flathead screwdriver.
Push down on the tabs inside the slots (as shown in the provided instruction picture).
Gently pull and remove the original handle.
Snap the new Cobra handle into place.
