Heltec T096 18650 Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is my 3rd iteration on coming up with the most compact I can make a Heltec T096 and 18650 battery.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 359
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is my 3rd iteration on coming up with the most compact I can make a Heltec T096 and 18650 battery.
Features
Lid clip to prevent bowing in the middle
Taller shape to fit the hand better.
Fits 18650 cell.
lanyard loop at the top.
I think the top might be possible to add a GNSS antenna but it's not required and I haven't tested it. should fit a 15x15x6 mm antenna.
Updated to add spring clip slots
Print Settings
Layer Height: First layer 0.2 and 0.16 after
Nozzle: 0.4
Material: PLA
Infill: 15%
Walls: 2
Supports: Not needed
Assembly
Put the battery in
Install SMA connector
Install T096 first by slotting the USB-C connector in first. (might need to sand the overhang)
Make sure the wires and antenna don't get in the way of the rails on the sides when pushing the T096 down.
Snap cover on and fasten with 4 M2*6 screws. (mine are Vigrue brand 1080 piece set)