Quick Release Airsoft RedDot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Quick Release Picatinny RedDot
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 86
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Do you have one of these cheap RedDot devices?
And have you had enough of fumbling with the allen keys when mounting these?
Fear no more, here comes the solution:
Simply click on your RedDot on any picatinny rail with two flicks in no time!
You need: 1x M4 x 20mm and 1x M4 x 35mm (or 40mm as these 35mm are hard to come by) allen screws
How to install:
Print right lever, leaner left lever and two hubs with your 3D printer: PETG or PLA with 100% infill.
The hubs have to be resized to 10% in the slicer. Screw the screws into the hubs all the way in. The screws must be turning, but tightly. Then take the screws out again.
Put the hubs into the levers. The 20mm screw goes into the right lever, the 35mm screw into the leaner left lever.
Screw them in all the way into the hub until the screw head sits flush in the hub and the hub can turn in the lever.
Now remove the two M4 screws from the RedDot that hold the side rail in place.
Put these screws aside for the unlikely case you might want to undo the procedure.
Now attach the side rail with the help of the quick mount levers.
Screw the right lever in at the back and the leaner left lever in at the front of the RedDot (see pictures).
Adjust the screws so the RedDot can be put onto a picatinny rail with a little wiggle while the levers are open (pointing away from the RedDot).
Then flick the levers shut and make sure the RedDot now sits snuggly in place and doesn't move.
Voila!